Size:

9cm x 6.6cm approx.

Vinyl Description:

• Gloss finish
• 3-5 years exterior application
• For indoors or outdoors
• Permanent acrylic adhesive
• Various Colours to choose from
• 10cm x 7.2cm approx.

These stickers are in 3 layers

• Plastic adhesive applique which enables the design to be lifted
• Design
• Paper Backing

Comes with instructions on how to apply vinyl decals. Decal Application Instructions:  Five steps to applying vinyl decals:

Vinyl should be applied to smooth surfaces only.

STEP 1:  Clean the surface

Clean the application surface and let it dry completely-rubbing alcohol is recommended.

Make sure your surface is ready for decals.  It should be a clean, smooth and dust-free surface.  If necessary wipe the area before labelling.  Before proceeding to the next step, make sure that the area is good and dry.

STEP 2: Peel off the backing

Carefully peel of the paper backing to make sure the vinyl is completely stuck to the tape.

When you receive a decal or sticker, it may be covered with a layer of transfer tape and still adhere to the material backing. Remove the transfer tape and decal from the backing.

Slowly remove the tape from the backing while making sure that the decal does not stick to the backing.  If the decal does stick, use a scraper tool for vinyl or a bank/credit card to re-apply the decal to the transfer tape.

STEP 3: Align and press

Align the decals and carefully place the decals on the surface.

For precise application, measure and mark the position you want before placing the decal. If you don't like this placement at first, you can usually tear off the trasfer belt and the decal will not stick to the new surface.

Once you are satisfied with the placement, apply the decal. Carefully align the sticker on top, and then slowly lower it until it lays flat on your surface. If you preform this step in a hurry, you may end up forming bubbles or even wrinkles on the vinyl. Press the tape with your finers to start the application.

STEP4: Smooth

Use a scraper tool for vinyl or a bank/credit card to smooth the design from top to bottom on the surface. 

Use a scraper tool for vinyl or bank/credit card to ensure that the vinyl sticks firmly to the surface. Rub the vinyl hard from the middle and press out wards. Make sure you cover the whole surface with this process. You should not see bubbles.

STEP 5: Remove the transfer tape.

Starting at the corner, carefully remove the transfer tape by peeling back, And cure for 24 hours before washing.

Take a moment to complete this step. Starting from a corner, slowly peel the tape off your surface. Be careful not to lift part of the vinyl design. If it sticks to the transfer tape, put the tape back on the surface where it is sticking and use the scraper tool or bank/credit card again.